Print Settings

*We've noticed with slicing using Classic wall generator in majority of slicers that certain geometry particularly for the Grill Honeycomb Inserts is causing perimeters/walls to not join. Please make sure you check before printing. Using Arache seems to fix this issue.

Layer Height	0.2mm
Extrusion width	0.4mm, forced
Infill percentage	40%
Infill type	grid, gyroid, honeycomb, triangle, or cubic
Wall count	4
Solid top/bottom layers	5
Supports	None
Perimeter/Wall Generator	Arachne*

Tested & Printed using SuperSlicer 2.5.59.9, PrusaSlicer 2.7.4 & OrcaSlicer 2.1.0

There might be some screws or heat set inserts (definitely for the probe mounts on the fixed carriages) missing from the CAD file since not all variants are the same.

Klicky PCB heat sets are included in every parts kit I’ve ever seen so reference them. The others are all M3x5x4.

I’ve also used M3x5x5 on a few spots in my own prototypes, if in doubt measure the depth of the hole if you have the 5mm long ones.